Avery Dennison 64-Series - Settings at 64-XX Dispensers; Dispenser Types; Basic Settings

03/13 Rev. 5.08-01 USER MANUAL Einrichten
64-xx – 64-xx dispenser
17
Settings at 64-xx dispensers
Dispenser types
The 64-xx is available as „Dispenser M“ or „Dispenser A“ (see tab. 2).
Basic settings
The following table shows a basic setting for those parameters which are
most important for dispenser operation (see tab. 3). The setting can be
applied to both, type M and type A, with the purpose of using a
footswitch.
 It is not possible to connect two foot switches to the printer (USI and
Single Start) and use them simultaneously.
 Advice on setting parameters can be found in topic section Info printouts
and parameters.
Type Property Operating mode
64-xx Dispenser M
• Short dispensing edge with
label sensor
• Connector for start/stop
signal (e. g. for footswitch)
Printing/dispensing is triggered manually
(single start), e. g. by a footswitch. The
dispensed labels are taken off by hand.
Alternatively: Printing/dispensing is trigge-
red by the label sensor, if a dispensed
label is taken off.
64-xx Dispenser A
• Long dispensing edge
without label sensor
• Connector for start/stop
signal (e. g. for footswitch)
Printing/dispensing is triggered manually
(single start), e. g. by a footswitch. The
dispensed labels are taken off by hand.
Alternatively: The dispensed label is taken
over by an applicator.
[Tab. 2] Different configuration of „Dispenser M“ and „Dispenser A“.
Submenu Parameter Setting
SYSTEM PARAMETERS
Periph. device Dispenser
External signal Singlestart
Start print mode Pulse rising
DISPENSER PARA
Dispense Mode Real 1:1 Mode
Dispensposition 0 mm
Dispensing mode fast
Application mode Immediate Mode
Start source Foot switch
Dispensing edge short
Transport mode Dispenser motor
[Tab. 3] Basic setting of the parameters most important for dispenser operation - valid
for both dispenser versions.