03/13 Rev. 5.08-01 USER MANUAL Einrichten
64-xx – 64-xx dispenser
8
Inserting fan-folded material
1. Set the outer disc of the material unwinder to the width of the material.
2. Pull the material through the inlet opening (1) to the material guide with
the side to be printed showing upwards.
3. Then proceed as described in section Inserting material
on page 5.
[1] Pull the fan-folded mate-
rial through the inlet open-
ing in the rear side and
proceed then as described
under „Inserting material“.
To Next Page
Loading...
