Avery Dennison 64-Series - Connecting the signal source

11/14 Rev. 03 USER MANUAL Advanced Applications
AP 4.4 – AP 5.4 – AP 5.6 – AP 7.t – 64-xx – DPM – PEM – ALX 92x
5
Connecting the signal source
Footswitch Footswitches are available as accessory for both, 64-xx and AP 5.4/5.6 printers and
are shipped ready configured (see topic section Accessories ).
 Connect the footswitch to the singlestart connector [2A].
[2] Single-start connector (A) and I/O board signal connector (B) at AP 5.4 (left) and at AP 5.4 Gen. 2 or
AP 5.6 (right) respectively. Matching footswitch (C) with 3-point plug.
[3] USI signal connector (A) and singlestart connector (B) at a 64-xx.
If the printer is operated with a LTSI applicator, the footswitch
has to be connected to the USI!
Printer Article no. foot switch
AP 5.4, AP 5.4 Gen. 2, AP 5.6 A4053
64-xx Dispenser with LTSI A4053 + A7268
a
a) Adapter cable for connection to a USI.
64-xx Dispenser 97685
[Tab. 3] Article numbers for foot switches.
C
A
B
A
B
B
A