Avery Dennison 64-Series - Testing the connection; Sending a printjob

11/14 Rev. 03 USER MANUAL Advanced Applications
AP 4.4 – AP 5.4 – AP 5.6 – AP 7.t – 64-xx – DPM – PEM – ALX 92x
31
Testing the connection
1. Call the input window: Start > Programs > Accessories > Input prompt.
2. Enter the command „ping“ with the printers IP address, e.g. „ping 192.168.0.99“.
3. If the connection works properly, four answer lines appear in the input prompt win-
dow [19].
[19] Input prompt window after proceeding ping with the printers IP address.
 As an additional test, „ping“ can also be called with the IP address of the access
point. The default IP address of the Netgear WG602 is 192.168.0.227
If the printer doesn´t send back an answer, the connection doesn´t work properly.
Measures in this case are:
 Check all the above mentioned settings.
 Contact the network administrator for advice.
Sending a printjob
1. Have an Easy-Plug printjob ready (in this example: „test.txt“).
2. Send the printjob using the command „lpr“ [20].
[20] Sending a printjob using the lpr command
After some seconds, the printer should start printing.
 During data transmission, the LED at the WLAN CF card flashes.