12/14 Rev. 03 USER MANUAL Commissioning & Operation
64-xx
9
Operating modes
Offline mode Printer settings can be made when the device is offline. The offline mode is
normally active when the printer is switched on. Print jobs are received via
the selected interface but not processed.
To configure the printer so that it goes directly into online mode when swit-
ched on, set the parameter
SYSTEM PARAMETER > Active Mode to “Online”.
Online mode In online mode, print jobs are received and processed immediately. Possible
messages:
To stop printing, press the online button.
Message mode The printer uses status reports to signal an error or a particular operating sta-
tus. This message mode indicates that the printer is waiting to quit or for fault
clearance. When quitting, the printer switches from message mode to offline
mode (depending on the error and the progress of the last active process).
The status message 5001 (shown above) occurs when for example the prin-
ter is set for punched label material, but continuous form material without
punches has been inserted. In this case, the printer will continue to feed the
material for a few seconds before it generates an error message.
Status Reports: see topic section „Status Reports“.
OFFLINE 0 JOBS No jobs are waiting to be processed.
ONLINE 0 JOBS No jobs are waiting to be processed.
ONLINE 0: JOBS The current data transfer to the printer is shown on
the display. This is indicated by the dot on the bottom
right next to the number of loaded jobs.
Another point on half line height above the first
shows the interpreter status:
• No point: No data to interpete.
• Solid point: The interpreter is busy (still data left
in the spooler).
• Flashing point: The interpreter is waiting for data
required to complete a command (no data in the
spooler).
ONLINE 13 JOBS
Restcount: 25
During printing, the display also shows the number
of received print jobs (13) and the remaining number
of labels (25) to be printed in the current job.
ONLINE 13 JOBS
Restcount: endless
If a print job recognises an endless number of labels
to be printed, then the remaining number for this job
is also shown as endless.
Status 5001
No gap found
Messages are made up of the status number and a
brief descriptive text.
To Next Page
Loading...
