12/14 Rev. 03 USER MANUAL Commissioning & Operation
64-xx
8
– Chapter Offline operation on page 13 and
Chapter Online operation on page 14
– In topic section Info-Printouts and Parameter
Remote operator
panel
64-0x Gen. 3 (or higher) machines can be equipped with a remote operator
panel. For this, the printer must provide the appropriate - optional - connector,
see chapter Printer connections on page 5. The connection can be retro-
fitted (see service manual).
The button functions are the same as those on the standard operator panel.
Exception: The on/off switch is not available at the remote control panel.
With the remote control panel connected, both panels are active and show
the same information.
[10] Remote operator panel (article number A8293)
CAUTION!
Manipulating both operator panels simultaneously can cause malfunctions.
Always use only one operator panel at a time to operate the printer. (Using
both operator panels alternately is admissible).
CAUTION!
If the connection cable is longer than 2.5 m, EMC-caused disturbances can
occur.
Only use the factory-installed cable.
Don´t extend the cable.
To Next Page
Loading...
