11/14 Rev. 03 USER MANUAL Advanced Applications
AP 4.4 – AP 5.4 – AP 5.6 – AP 7.t – 64-xx – DPM – PEM – ALX 92x
28
Data transmission with WLAN
According to standard IEEE 802.11b
Requirements
Suitable printers
Revision number
CPU board
• AP 5.4, AP 7.t: at least 3 (A3927-03)
• 64-xx, DPM, PEM, ALX 92x, ALX 73x: at least 4 (A6621-04)
Displaying the revision number: SERVICE DATA > CPU BOARD DATA > CPU identifier
WLAN CF cards • D-Link „DCF-660W“ (article number A7456)
• Linksys „WCF12“ (no longer availabe)
• Pretec „OC-WLBXX-A“ (no longer availabe) [16A]
[16] WLAN CF card (A) ; Wireless Access Point (B)
Further requirements • Access point according to standard IEEE 802.11b station mode „infrastructure“ (e.
g. „Netgear Wireless Access Point WG602“ [16B])
• Ethernet crossed link cable (1:1 cable), to connect the access point to the host
computer
• PC with operating system Windows XP
Notes
WLAN = Wireless Local Area Network
This section describes a simple setup, with which data transmission from a host com-
puter (e. g. PC) via an access point to a label printer can be testet. This setup doesn´t
suit for real network operation.
Printer Firmware
AP 5.4, AP 7.t 3.00
64-xx, DPM, PEM, ALX 92x (each Gen. 3) 5.31
ALX 73x 6.36
[Tab. 20] Minimum firmware versions for use of WLAN.
To Next Page
Loading...
