11/14 Rev. 03 USER MANUAL Advanced Applications
AP 4.4 – AP 5.4 – AP 5.6 – AP 7.t – 64-xx – DPM – PEM – ALX 92x
29
Printer setup
1. Insert the WLAN CF card into the printers card slot. Switch the printer on.
In the printer menu INTERF. PARAM. > NETWORK PARAM., additional parameters for
WLAN operation show up.
The LED at the card is flashing as long as the card is not logged in at the access
point.
2. Make the following settings in the INTERF. PARAM. > NETWORK PARAM. menu:
3. Set parameter INTERF. PARAM. > EASYPLUGINTERPR > Interface to „LPD Server“.
4. Restart printer to activate the settings.
Connecting
1. Connect the access point to the PC using a crossed link cable. Connect the ac-
cess point to the mains supply and switch it on.
2. Check, if the LED at the WLAN CF card lights up permanent. If it does not, check
the following points:
– Is the card plugged firmly into the card slot?
– Does the card match one of the supported card types?
– Is the parameter INTERF. PARAM. > NETWORK PARAM. > WLAN SSID set to „idt“
(small letters!)?
CAUTION! - Network manipulations can disturb or avoid proper network operation.
Before connecting any device to a network, always ensure the approval of the net-
work administrator.
Parameter Setting Note
IP addressassign Fixed IP address
IP address
e. g.
192.168.000.999
ask the network administrator for it;
the initial three bytes must equal
the PC address
Net mask 255.255.255.000 = default setting
WLAN SSID idt use lower case letters
WLAN WEP disabled
WLAN default key 0 or any other setting
FTP server arbitrary setting
WEB Server arbitrary setting
[Tab. 21] Required parameter settings in the printer menu.
To Next Page
Loading...
