Model E1010 Indicator User Instructions 15
5 PLU (Product Look Up) Memory Channels
This indicator has 10 channels of memory called PLU or Product Look Up. Each
channel can contain the following information:
l Channel #
l ID#
l Ta r e
l Gross Accum.
l Net Accum.
l To tal
l TARGET OP1
l TARGET OP2
l TARGET OP3
l Lower Limit
l Upper Limit
l Count Accum.
l Piece Weight
l Peak Weight
1. To activate or recall a PLU, key in the desired channel number (0-9) and press
the F1 key…
The PLU channel is active. Any of the items listed above that have
values are activated. Any values that are listed above that change while
this PLU is active are stored, ie; accumulator, count, etc.
2. PLU channels can be cleared by using a password protected menu. These
instructions are found in the Supervisor Menu on page 18. You can also print a
report of all the PLU channels in the same password protected menu.
If there are preset tares in the PLUs, you cannot enter a keyboard or pushbutton tare.
Preset tares are enabled and entered under the Supervisor Menu on page 17.
If preset tares are not enabled, any tare you enter by keyboard or pushbutton method
will be active for all PLUs.
To Next Page
Loading...
Need help?
General
