Model E1010 Indicator User Instructions 31
8 Indicator Operations
The E1010 comes equipped with several weighing applications;
l General weighing (default setting)
l Accumulator weighing
l Batch weighing
l Checkweigher
l Counting
l Peak capture
l Remote display
These applications are enabled using a password protected menu. Contact your local
supplier or Avery Weigh-Tronix distributor for assistance with the password protected
menu. Also see SETUP submenu (Setup menu) on page 20 in this manual for
configuring a specific application.
If multiple applications are enabled, you can switch between them by pressing the
MODE key. The display will briefly show the application name when you press the
MODE key.
The general weighing application comes as the default application. You can do gross
weighments and tare/net weighments. Below are instructions for each.
8.1 General Weighing
To perform gross weighing, power up the unit and follow these steps:
1. Empty the scale and press ZERO key to zero the display…
0 is displayed and gross and center of zero annunciators are lit.
2. Place item to be weighed on the scale…
Weight is displayed.
When the indicator goes to sleep you must press the ON/OFF switch to restart the
indicator.
This indicator has a 10 channel PLU (Product Look Up) memory. To access a memory
channel, press a number from 0 to 9, then press the F1 key.
To change unit of measure, press the UNITS key.
To Next Page
Loading...
Need help?
General
