26 Model E1010 Indicator User Instructions
TOP (Peak Weight Application)
1. Press the UNITS key…
TOP is displayed. Use this item to clear and print reports for the peak
application.
2. Press the PRINT key…
PRINT is displayed. Use this item to print out a complete report of peak
application information.
3. Press the ENTER key …
Display shows BUSY briefly then returns to PRINT.
4. Press the UNITS key…
CLEAR is displayed. Use this item to clear all the information stored for
this application. WARNING - Only do this if you are sure you want the
information permanently removed!
You may want to print out the report before clearing all the information.
5. Press the ENTER key…
SURE? is displayed.
6. Press the ESC key to abort the save process or press the ENTER key to clear
all the information…
CLEAR is displayed.
7. Press the SELECT key repeatedly until SETUP is displayed.
This concludes the Application section of the Supervisor menu.
7.2.4 TEST submenu (Test menu)
1. Enter the Supervisor men and press the UNITS key repeatedly until…
TEST is displayed. This menu lets you view indicator information and
test the scale, the display, keypad, serial port, inputs and outputs.
ABOUT (Indicator information)
2. Press the PRINT key…
ABOUT is displayed. Press the PRINT key then the UNITS key to view
the part number and revision level for the software found in your
indicator.
Press SELECT key to return to ABOUT.
ADC (Analog to Digital converter)
3. Press the UNITS key…
ADC is displayed. This stands for the analog to digital converter value in
mV/Vs.
To Next Page
Loading...
Need help?
General
