Model E1010 Indicator User Instructions 41
8.7 Peak Weighing
This section applies if your indicator has the Peak application active.
Peak weight is defined as the highest stable weight reached by the scale. Momentary
higher weights that do not stabilize are ignored.
While in Peak mode, the Peak annunciator remains lit.
Follow these steps to perform a peak weighment:
1. Empty the scale and press the ZERO key to zero the display…
0 is displayed.
2. Place the item(s) on the scale…
Weight is displayed.
3. After the motion annunciator (~) turns off remove the item(s) from the scale,
The peak weight is displayed and the center-of-zero annunciator lights.
4. To clear the peak value, press the F1 key…
0 is displayed.
5. Repeat steps 2-4 for other weighments.
Use the SELECT key to scroll through G, T, N and peak values
This indicator has a 10 channel PLU (Product Look Up) memory. To access a memory
channel, press a number from 0 to 9, then press the F1 key.
The peak hold option is available on AWT30-500047. Contact your Avery Weigh-
Tronix distributor for more information.
To Next Page
Loading...
Need help?
General
