50
Model E1010 Indicator Service Manual
Supervisor Menu—SETUP submenu (continued)
1. Press the UNITS key…
TOP is displayed. Use this item to clear and print reports for the
peak application.
2. Press the PRINT key…
PRINT is displayed. Use this item to print out a complete report of
peak application information.
3. Press the ENTER key …
Display shows BUSY briefly then returns to PRINT.
4. Press the UNITS key…
CLEAR is displayed. Use this item to clear all the information
stored for this application. WARNING - Only do this if you are
sure you want the information permanently removed!
You may want to print out the report before clearing all the informa-
tion.
5. Press the ENTER key…
SURE? is displayed.
6. Press the ESC key to abort the save process or press the ENTER key to
clear all the information…
CLEAR is displayed.
7. Press the SELECT key repeatedly until SETUP is displayed.
This concludes the Application section of the Supervisor menu.
TOP (Peak Weight Application)