27
Model E1010 Indicator Service Manual
Extra Info:
Print Format Editing
FF is the hex. value for End of
String (EOS). When this value
is entered in a print format, any
values beyond this in the
sequence are ignored and the
display will wrap back to the
001 item.
You can overwrite the FF value
and use up to the maximum
string length if so desired. In
the E1010 the maximum
sequence length is 128.
The first three numbers are the sequence of the print commands.
The last two characters are the hexadecimal number for the print
command.
Use the keys as described in Figure 7 to scroll through the se-
quence and change the hex. character value.
Figure 7
Key legend for hex editing
TARE key- moves to the previous sequence number
SELECT key - increments hex number
ZERO key- decrements first digit of hex number
PRINT key- decrements hex number
UNITS key- moves right through the print string
ENTER key- Accepts print string and exits edit mode
ON/OFF key- A short key press inserts a new character in front
of the displayed character. Press and hold to
delete the currently displayed hex character.
Hex values of 7F (127 decimal) and below are printable characters
and can be seen in Table 1. Hex values from 80 (128 decimal) to
FF (255 decimal) is for print command tokens and can be seen in
Table 2. See note at left.
The default print format for the accumulator application is shown
in a sample printout on the next page.
To Next Page
Loading...
Need help?
General
