31
Model E1010 Indicator Service Manual
SERIAL submenu
Follow these steps to access each item in the SERIAL menu and to under-
stand what they do and how to set them:
1. Access the Service menu. . .
CAL is displayed.
2. Press the UNITS key repeatedly until. . .
SERIAL is displayed.
3. Press the PRINT key. . .
BAUD is displayed. Use this item to set the baud rate. Choices
are from 300 to 115,200. Default is 9600.
4. Scroll the choices by using the UNITS key or TARE key and press the
ENTER key to accept the displayed choice. .
BAUD is displayed.
The next section of the Service menu is the SERIAL submenu. See Figure
8. This menu lets you configure the serial port and create custom print
formats #1-9.
Figure 8
SERIAL (serial communication) submenu
BAUD
(Baud rate)
The default serial port param-
eters are 9600 baud, 8 dat-
abits, no parity and 1 stop bit.
Stop bits for the serial
communication are preset to
1 stop bit. This is not config-
urable.
Service Menu—SERIAL submenu
To Next Page
Loading...
Need help?
General
