Avigilon ENVR2 Plus User Manual

l
Discover the DHCP-assigned IPaddress from the ACC Client software:
l
Log into the site that uses this naming convention: ENVR2-PLUS-8Px-<serial number>.
Note: The username and password for the Web Interface application is separate from
the administrator username and password for the ACC Server.
l
Access the appliance from your web browser using the URLhttps://ENVR2-PLUS-8Px-<serial number>.
l
Use the Address Resolution Protocol (ARP) to determine the IP address for the device:
1. Locate and copy down the MAC Address (MAC) listed on the Serial Number Tag for reference.
2. Open a Command Prompt window and enter the following command:
arp -a
3. Scroll through the response and look for the IP address corresponding to the MAC address.
If none of the above suggestions resolve the problem, contact Avigilon Technical Support.
Network Configuration
By default, the ENVR2 Plus Appliance acquires an IP address on the network through DHCP. If you need to
set up the ENVR2 Plus Appliance to use a static IP address or any specific network configuration, see the
Connecting to the ENVR2 Plus Appliance (using Static IP) on page10 for more information.
Monitoring System Health
You can monitor the health of the system components in the Site Health in the ACC Client software. See the
Help files provided with the ACC Client software, or the Avigilon ACC Client User Guide available from the
Avigilon website for more information.
Network Configuration 13

Avigilon ENVR2 Plus Specifications

General

Brand	Avigilon
Model	ENVR2 Plus
Category	Network Hardware
Language	English