Mounting with the Optional Rack Mount Kit
Install the ENVR2 Plus Appliance in a location free of dust and particles, vibration, and within the specified
operating temperature range. Otherwise any issues that arise will not be covered by the warranty.
Tip: You may want to mount the appliance before or after you have made all the required
connections depending on where you want to mount the device. See Connecting the Hardware on
page9 for more information on the required connections.
If you are not using the rack mount kit, refer to the instructions for the mounting option you are using:
l
Mounting to the Wall with the Supplied Brackets on page7
l
Mounting with the Optional DIN Rail Mount Kit on page45
Follow these instructions to mount the ENVR2 Plus Appliance with the optional Rack Mount Shelf With Sliding
Rails accessory kit (RMS1U-ENVR2-8P).
Important: The rails are designed for rack units with square mounting holes only.
The mounting rails are designed in pairs, with a right and left rail. Each rail is clearly marked to indicate the
side of the rack unit it must be attached to, as well as the top and front edges. Before starting, check each
mounting rail to verify on which side of the rack the rail is attached. The rail length is adjustable from 641 mm
to 910 mm (25.236" - 35.827").
There is a risk of injury and damage to equipment if the appliance falls out of a rack unit. It is extremely
important that the ENVR2 Plus Appliance is securely fastened to the mounting rails.
Ensure that the location of the appliance in the rack unit does not impede airflow through the
appliance.
Mounting with the Optional Rack Mount Kit 41
To Next Page
Loading...
Need help?
General
