Avigilon ENVR2 Plus User Manual

a. Open a web browser from a network workstation with network access to the device.
b. Enter its IP address or hostname into the web browser to open the device sign-in page:
https://<Device IP address >|<Device hostname>/
For example:
l
https://169.254.100.100/ where 169.254.100.100 is the IP
address configured in the Device panel.
l
https://my_AvigilonDevice/ , where my_AvigilonDevice/ is the
hostname configured in the Device panel.
Note: If you forgot the IPaddress or hostname that was configured during the
installation process, the information is listed in the ACC Client software, in the
server Setup tab.
c. Bookmark the device sign-in page.
LogoutandstopServerManagementbyclickingthelogouticonontherightoftheServerManagementtitlebar.
Viewing PoE Port Status
The PoE panel displays a status for each port in the Status column. Statuses include the following:
Color Status Description
Green
Powered A PoE device is connected to the port and is operating normally.
High powered PoE+ is turned on.
Gray Disconnected
There is no device connected to the port.
The PoE port power is switched off from the PoE page in Server Management.
Yellow
Overloaded
A PoE device is connected to the port but is not receiving power. This status
typically occurs when one port is over current, or the device is requesting
more power than budgeted, etc.
Low current The device is getting low current from the port.
Red Error The device is in an error state.
Tip: If a camera is disconnected then reconnected to the device, you may need to refresh this page
to view the latest status and budget values.
Viewing PoE Port Status 22

Avigilon ENVR2 Plus Specifications

General

Brand	Avigilon
Model	ENVR2 Plus
Category	Network Hardware
Language	English