Installing the Dome Cover
Be careful not to touch or scratch the dome bubble. Any marks or fingerprints on the dome bubble may cause
unwanted reflections from the IR illuminators.
1. Discard the desiccant pack that is glued to the camera base.
2. On the new desiccant pack provided with the camera, remove the adhesive backing and fold down
the sides over the adhesive.
3. Place the new desiccant pack in the same location as the old pack and make sure it sticks to the
camera.
4. Attach the dome cover to the base.
Tip: Make sure the IR contacts are aligned to fit the dome cover to the base.
Installing the Dome Cover 30
To Next Page
Loading...
