Avigilon H6SL Series - User Management; Adding New Camera Users

than the Washer Period to give the wiper time to clean the window after the spray has stopped.
Audio
Use the settings on the Audio page to adjust the audio quality of the camera.
For encoding the audio stream, you can choose from the Opus sound encoder, which produces high-quality
sound, or the G.711 protocol sound encoder. Use the Opus encoder if you are using ACCsoftware Release
6.10 or later (or a third-party video management system that supports the Opus protocol). Otherwise use the
widely supported G.711 protocol.
1. In the Audio Settings section:
a. In the Encoding field, specify the audio encoder to use:
l
Opus:Default high quality audio codec.
l
G.711: Supported on various platforms.
2. In the Device Speaker section, use the Volume slider to adjust the volume on the speaker (from 0 to
100).
3. In the Device Microphone section:
a. Use the Line in Gain setting to adjust output of the microphone that is built into the camera.
4. Click Apply to save your changes.
Users
On the Users page, you can add new users, edit existing users, and change passwords.
Adding a User
1. On the Users page, click Add....
2. On the Add User page, enter a User Name and Password for the new user.
3. In the Security Group drop-down list, select the access permissions available to this new user.
l
Administrator: full access to all the available features in the camera web interface.
l
Operator: has access to the Live View but limited access to the Setup features. The user can
access the General page, Image and Display page, Compression and Image Rate page, Motion
Detection page, Privacy Zones page, Digital Inputs and Outputs page, Microphone page and
the Speakers page. The new user can also configure onboard storage settings but cannot
delete video recordings or format the SD card.
l
User: has access to the Live View, but cannot access any of the Setup pages.
4. Click Apply to add the user.
Audio 32