ACC™ ES Camera
If you are configuring an H4 Edge Solution (ES) camera, you will see the ACC ES application option in the left-
menu pane.
H4 ES cameras feature a server component that runs the Avigilon Control Center Server software. This allows
each H4 ES camera to also act as its own site and server.
From the ACC ES application pages, you can configure the streaming ports and archiving settings for the
ACC Server software.
Checking the ACC ES Camera Status
On the first ACC ES application page, you can check the status of the Avigilon Control Center software.
l
Avigilon Control Center Information
o
ACC Site Name — The name of the site that the camera is part of.
o
ACC Server Name — The name of the camera.
o
ACC Server Status — The status of the ACC Server software.
o
ACC Server Version — The version of the ACC Server software.
Configuring the ACC ES Camera Administration Settings
On the Setup page, you can configure the Avigilon Control Center system admin settings like you would in
the ACC Admin Tool.
Restarting the ACC Software
If the ACC Server software is not operating as expected, you can try to resolve the issue by restarting the
server component.
1. On the Setup page, click Disable ACC ES.
2. Click Apply.
The camera shuts down the ACC Server software.
3. Click Enable ACC ES to restart the ACC Server software.
Formatting the Recorded Video Drive
ACC ES HD cameras include a solid state drive that stores recorded video directly on the camera. If you ever
need to delete all configuration and recorded video data, you can reinitialize the storage.
ACC™ ES Camera 37
To Next Page
Loading...
Need help?
General
