Setup
Note: Certain options are not displayed if they are not supported by the camera model you are using
or if you do not have the required user permissions.
The factory default settings allow you to use the camera or encoder immediately after installation. If you have
special requirements, you can customize the settings through the web interface. In the top-left menu area,
click Setup to display all the available setup pages.
A Restore Defaults button is available on each setup page to restore the factory default settings.
Be aware that some settings are only available through the camera's web interface and cannot be changed in
the network video management software.
For information specific to H4 Edge Solution (ES) cameras, see ACC™ ES Camera on page37.
For settings that are specific to the H4 Thermal Elevated Temperature Detection cameras, see the H4
Thermal Elevated Temperature Detection Camera User Guide.
Setup 5
To Next Page
Loading...
Need help?
General
