Access the PTZ menu using the joystick knob, search for the camera, select the camera to be connected,
and customize the camera ID if desired. And select the corresponding protocol from the menu that there
are VISCA-IP and Onvif available for network connection. Last, toggle the connection switch to establish
the connection.
There are 3 ways we can call the camera we want to control:
1. Set the call option to Follow PGM, which means the controlled camera is same to the selected PGM
channels from Camera 1-6. For example, when the PGM is selected the Camera 2 (IN 2), then the
Camera 2 is under control.
2. Set the call option to Follow PVW, which means the controlled camera is same to the selected PGM
channels from Camera 1-6. For example, when the PVW is selected the Camera 2 (IN 2), then the
Camera 2 is under control.
3. If set the call option to Camera ID, then we can set the ID option from camera 1-6.
For connection through serial port, select the corresponding protocols from VISCA, PELCO-D, PELCO-P,
and camera ID, and baud rate, serial port type settings. Subsequently, enable the connection switch to
establish the connection.
Once the camera is connected, employ the 3D joystick to control camera movement. The zoom function
can be operated using the zoom + or zoom - buttons on the panel. We also can adjust the Pan/Tilt/Zoom
speed in the PTZ menu as needed.
15. SYSTEM SETTINGS
15.1. Language
Switch between English and Chinese by accessing the system settings menu.
To Next Page
Loading...
