Revision Date: 1/17/2020
1. Introduction
About This Manual
This Owner’s Manual describes how to install, set up and operate the Avocor Series LED Display.
Throughout this manual, the Avocor Series LED Display is referred to as the “display”.
Target Audience
The manufacturer has prepared this manual to help installers and end users get the most out of the display.
The manufacturer has made every effort to ensure that this manual is accurate as of the date it was printed.
However, because of ongoing product improvements and customer feedback, it may require updating from
time to time.
Textual and Graphic Conventions
Text Conventions: The following conventions are used in this manual, in order to clarify the information and
instructions provided:
Remote and built-in keypad button identifiers are set in upper-case bold type; for example, “Press EXIT to
return to the previous menu.”
Computer input (commands you type) and output (responses that appear on-screen) is shown in
monospace (fixed-width) type; for example: “To change the aspect ratio to Letterbox, type 07 00 02 41
53 50 03 08 <OK>.”
All keys with functional names are initial-capped, set in bold type and enclosed in angle brackets. These
keys are the following: <OK>, <Spacebar>, <Control>, <Esc> and <Tab>. <OK> indicates that you may
press either the EXIT or OK key on your keyboard if it has both keys.
In addition to these conventions, underlining, bold face and / or italics are occasionally used to highlight
important information, as in this example:
NOTE A carriage return must be used after each command or string.
To Next Page
Loading...
Need help?
General
