Revision Date: 1/17/2020
3. Installation
NOTE Installation must be performed by a qualified custom video installation specialist.
Remote Control
To install batteries in the remote control:
1.
Press down the tab on the cover and pull the cover up.
2.
Insert the included batteries. Ensure that the polarities correctly match the and markings inside
the battery component.
3.
Insert the lower tab of the cover into the opening, and press down the cover until it clicks in place.
Notes on Batteries
Make sure that the battery polarities are correct when installing the batteries.
Do not mix an old battery with a new one or different types of batteries.
If you will not use the remote control for a long time, remove the batteries to avoid damage from battery
leakage.
Do not expose batteries to excessive heat such as from sunshine, fire or the like.
Notes on Remote Control Operation
Make sure that there is nothing obstructing the infrared beam between the remote control and the IR
receiver on the display.
If the effective range of the remote control decreases, or it stops working, replace the batteries with new
ones.
The remote control may fail to operate if the infrared remote sensor is exposed to bright sunlight or
fluorescent lighting.
Ambient conditions may possibly impede the operation of the remote control. If this happens, point the
remote control at the display, and repeat the operation.
To Next Page
Loading...
Need help?
General
