FREQUENTLY-USED FUNCTIONS
20
207
5. FREQUENTLY-USED FUNCTIONS
5.1 IP Device Search
Note: This function is applicable only for our brand’s IP camera. For other brand’s IP camera, please
check its user manual to know how to change the IP address manually under the network
segment of 10.1.1.xx (xx ranges from 11 ~ 253).
Go to MENU CAMERA CONNECTION, and select IP SEARCH at the bottom right corner. You’ll see
the list of every connected IP camera with its connection status to this device and MAC address.
IP SEARCH
ASSIGN EDIT DEVICE TYPE IP NETMASK GATEWAY PRIMARY DNS PORT MAC VENDOR
IPCAM 10.2.1.33 255.255.255.0 10.2.1.10 8.8.8.8 88 00:0E:53:31:06:E5 AVTECH
REFRESH ADD
Make sure the IP address of the connected camera is under the network segment of 10.1.1.xx (xx ranges from
11 ~ 253). If not, select and change the network type from STATIC to DHCP. Then, Click APPLY to save
your changes.
SETUP
NETWORK TYPE DHCP
IP 10.1.1.14
PORT 88
USER NAME Admin
PASSWORD *****
NETMASK 255.255.255.0
GATEWAY 10.1.1.10
PRIMARY DNS 8.8.8.8
CANCEL APPLY
Check to assign the camera to a specific channel automatically, and choose ADD.
IP SEARCH
ASSIGN EDIT DEVICE TYPE IP NETMASK GATEWAY PRIMARY DNS PORT MAC VENDOR
CH1
IPCAM 10.1.1.14 255.255.255.0 10.1.1.10 8.8.8.8 88 00:0E:53:31:06:E5 AVTECH
REFRESH ADD
To Next Page
Loading...
