MAIN MENU
44
447
6.6 STORAGE
In this menu, you can check the status of each connected hard disk and configure some precaution actions to
protect each hard disk and the video data saved in it such as reminding of hard disk erasing or avoiding the hard
disks being over-heated.
STORAGE
HDD NEARLY FULL (GB) 5
HDD OVERHEAT ALERT (°C) 70
OVERWRITE ON
KEEP DATA LIMIT(DAYS) OFF
TEMPERATURE TO ENABLE FAN (°C) 30
REMINDER WHEN FORMATTING HDD OFF
ID TYPE STATUS
SIZE TEMP.
SERIAL NUMBER FREE SIZE FORMAT TIME HEALTH STATUS
HDD2 NORMAL READY 750GB 33°C WD-WCAV53797317 269.856GB
2017/07/18 23:03:52 GOOD
1) HDD NEARLY FULL (GB)
If HDD BUZZER is enabled in MAINTAIN, select the duration time for buzzer notifications when the hard
disk available capacity is 5/10/15/20 GB left.
2) HDD OVERHEAT ALERT (°C)
Select the temperature alert for your hard disk to be aware of the possible overheat of your hard disk.
3) OVERWRITE
Be defaults, the HDD overwritten function is set to ON, and will be shown on the screen.
4) KEEP DATA LIMITS (DAYS)
Assign how many days to save the recording data from 1 to 31 days. After the assigned day(s), the recorded
data will be removed. Select OFF to disable this function.
5) TEMPERATURE TO ENABLE FAN (°C)
Choose the temperature (25 / 30 / 35 / 40) to enable the built-in fan to work for heat dissipation.
6) REMINDER WHEN FORMATTING HDD
Enable this function to allow the recorder to prompt first when it needs to format your hard disk; otherwise the
recorder will format the hard disk without asking.
7) HDD information
You can check the remaining capacity of the connected hard disk in this device and its current status.
If the health status goes to:
GOOD - This hard disk works normal.
BELOW AVERAGE - The hard disk might work with some errors. Please pay attention and do video backup if
needed.
REPLACEMENT NEEDED – Please replace this hard disk immediately to ensure continuous video recording.
8) HDD details
You can check the details of the selected hard disk.
9) HDD formation
Click to format the selected hard disk and erase all data. When a hard disk is inserted to the recorder for the
first time, it’s compulsory to format the hard disk for it to work properly.
To Next Page
Loading...
Need help?
General
