MAIN MENU
32
327
6.3 SCENARIO
This function allows you to customize a series of actions which will be run automatically after the specified event
occurs.
Several scenario rules are pre-defined for you to quickly choose and apply. If none of these rules are suitable for
you, you can choose to create your own rule from several scenario templates.
SCENARIO
EDIT NAME TRIGGER ACTION TIMER STATUS
MOTION RECORD ALL CHANNELS START RECORDING EVENT CHANNEL OFF
ALARM RECORD ALL CHANNELS START RECORDING EVENT CHANNEL OFF
GUARD RECORD GUARD START RECORDING ALL CHANNELS ON
PUSH VIDEO NOTIFICATIONS (PIR) GUARD,MOTION(CH1), PIR(CH1)… PUSH VIDEO TO SEE PLAYBACK ON
PUSH VIDEO NOTIFICATIONS
(ALARM)
GUARD,MOTION(CH1),ALARM(CH1)… PUSH VIDEO TO SEE PLAYBACK ON
MANUAL RECORD START RECORDING ALL CHANNELS EVERYDAY ON
PUSH STATUS ALL SYSTEM STATUSES PUSH STATUS EVERYDAY ON
EVENT POP-UP ON LIVE MONITOR
(MOTION & ALARM)
MOTION(ALL CHANNELS),ALARM(ALL
CHANNELS)
POP UP EVENT ON LIVE MONITOR ON
GUARD ON (MOTION DETECTION)
GUARD ON
GUARD ON (PIR DETECTION) GUARD ON
GUARD OFF (MOTION
DETECTION)
GUARD ON
GUARD OFF (PIR DETECTION) GUARD ON
EVENT POP-UP ON EVENT
MONITOR (MOTION & ALARM)
MOTION(ALL CHANNELS),ALARM(ALL
CHANNELS)
PLAYBACK VIDEO ON EVENT MONITOR ON
6.3.1 Pre-defined Scenarios
There are 13 pre-defined scenarios for you to quickly enable the recording and notification functions which are
used frequently.
Note: All pre-defined scenarios are not editable. If any changes should be made to suit your need,
please add a scenario rule manually.
1) MOTION RECORD
All channels are selected in this rule. The recorder starts recording the channel which has a motion event.
Scenario template used: ONE OF (EVENT) TO (RECORD).
2) ALARM RECORD
All channels are selected in this rule. The recorder starts recording the channel which has an alarm event.
Scenario template used: ONE OF (EVENT) TO (RECORD).
Note: The alarms here refer to the alarm devices connected to the IP cameras or the NVR. For the
alarm events triggered by the PIR sensor built into the camera, please choose PIR instead.
3) GUARD RECORD
When Guard is enabled from EagleEyes, our mobile app, the recorder starts recording all channels.
Scenario template used: ONE OF (EVENT) TO (RECORD).
4) PUSH VIDEO TRIGGERED BY BUILT-IN PIR SENSOR (For selected models only)
When motion & PIR events occur simultaneously, you’ll receive Push Video on your mobile device.
Scenario template used: ALL OF (EVENTS) TO DO (ACTION) AND THEN (ACTION).
Note: To know how to enable Push Video, please refer to “APPENDIX 2 PUSH VIDEO CONFIGURATIO”
at page 72.
To Next Page
Loading...
Need help?
General
