MAIN MENU
43
437
6.5.3 REGULAR REPORT
This function is used to send event reports to the specified E-mail address. Users could configure up to 5
profiles to receive different reports about specific channels at different time.
Note: This function is available only when a hard disk is installed, and the recorder is connected to
Internet.
You can configure up to 7 profiles and use one of them as your backup preference.
BACKUP
SOURCE DESTINATION
PROFILE PROFILE1 EVENT TYPE 4 SELECTED
ACTIVE ON
EXECUTION PERIOD WEEKLY
EDIT E-MAIL ADDRESS
EXECUTION DAY OF WEEK MON
tech_support@gmail.com
EXECUTION HOUR 1
CHANNEL √ ALL
CH1
CH2
CH3
CH4
CH5
CH6
CH7
CH8
CH9
CH10
CH11
CH12
CH13
CH14
CH15
CH16
APPLY
Step1: In SOURCE, choose the profile you’d like to save all the settings configured in SOURCE.
Choose how often and when you’d like to receive reports. Finally, make sure this profile is active
(ACTIVE to ON).
EXECUTION PERIOD Select how often you want to receive reports: MONTHLY, WEEKLY or DAILY.
EXECUTION DAY OF MONTH /
EXECUTION DAY OF WEEK
Depending on the option you selected in EXECUTION PERIOD:
EXECUTION DAY OF MONTH shows when MONTHLY is selected.
Select one date from 1 ~ 31 to reboot.
EXECUTION DAY OF WEEK shows when WEEKLY is selected. Select
one day from Monday ~ Sunday to reboot.
Step2: In CHANNEL, check the channel(s) you want.
Step3: In DESTINATION, choose which event type(s) you want to see (MANUAL / MOTION / ALARM /
SYSTEM / TIMER / HUMAN DETECTION).
Step4: Click to manually add an Email address to receive reports or to select from the E-mail address
list pre-defined in NETWORK E-MAIL, to modify the selected Email address, and to remove
the selected Email address from the recipients list.
Step5: Click APPLY to confirm.
To Next Page
Loading...
Need help?
General
