AWA E-E07H - Basic Operation

18

BASICOPERATION
1.ConnecttheACpowercordtothewalloutlet.
2. Remove white protective needle cover by gently pulling downward toward
frontofunit.Keepneedlecoverinasafeplacewhennotinuse. 

3. Screw the balance weight which comes with the product on the tone arm
ontothescalemark.RefertopicturesA&Bbelow.

Thebalanceweightistoadjustthepressureoftheneedle.Ifthepressureistoo
much, the sound will become distorted; if the pressure is too little, track
skipping will easily happen. Please adjust the balance weight by turning the
balanceweightclockwiseorcounterclockwiseperinstructionsbelow.

x  Putthebalancewe
ightintoscalemark
 ofthetonearm,thenrotateitto
thedesignatedpositionofthescalemark .
x  Rotate the balance weight counterclockwise so that it moves outward
towardsposition
 iftrackskippingoccurs.
x  Rotate the balance weight clockwise so that it moves inward towards
position  ifthesoundisdistortedorthebasspoor.
x  Fine tune the balance weight position between
 and  to achieve
optimumsoundperformance.

NOTE: 
x   Donottrytoadjustthebalanceweightwhileplayingarecordasthiscould
breaktheneedleandscratchtherecord.
x   Pleaseremovethebalanceweightbeforetransportationtopreventdamage
orbreakagetotheunit.

4.PressthePOWERbuttontoturntheplayeron. 
