40
AXIS 231D - System Options
Caution!
Plain Config - this function is for the advanced user. All parameters can be set and
modified from this page, help is available from the standard help pages.
About
Third Party Software Licenses - click View licenses for a list of the licensed software used
in the AXIS 231D Network Dome Camera.
Resetting to Factory Default Settings
To reset the AXIS 231D to the original default settings, go to the System Options |
Maintenance web page (described in Maintenance, on page 38) or use the control button
on the AXIS 231D as described below:
Using the Control Button
Follow the instructions below to reset the AXIS 231D to factory default settings using the
Control Button.
1. Switch off the AXIS 231D by disconnecting the external power supply.
2. Using a suitably pointed object, press and hold the Control button while you
reconnect the power supply.
3. Keep the Control button pressed until the Power Indicator flashes amber (this may
take up to 15 seconds).
4. Release the Control button.
5. When the Power Indicator changes to green (may take up to 1 minute), the process is
complete and the AXIS 231D has been reset.
Improper use may cause unexpected behavior or even cause loss of contact with the unit. If a script does cause
problems, reset the unit to its factory default settings (in which case, a backup file may be of use to return the
unit to its latest configuration). Axis strongly recommends that you do not use this function unless you
fully understand the consequences. Note that Axis Customer Services will not assist with customized scripts.
For more information, please visit the Developer pages at http://www.axis.com/developer
To Next Page
Loading...
Need help?
General
