Axis AD Series - 8. Preparing a balance to work

10 USER MANUAL
_________________________________________________________________________________________________________________
8. Preparing a balance to work
1. Take all content out of a
package. It is recommended to
keep the original scale package in
order to transport the balance
safely in future.
2. Place the balance on a stable
ground not affected by
mechanical vibrations and
airflows.
3. Level the balance with rotating
rear legs 6 so that the air bubble
in water-level at the back of the
balance is in the middle.
4. (AD50-AD500) Put a pan base
2 on the mandrel sticking out of
a balance cover 3. Put a pan 1 on
a pan base (pan 150mm is
connected to pan base).
5. (AD6) Put elements 2 on the
mandrel sticking out of
a balance, put a pan 1 .
6. Plug a feeder to the power
socket at the back of the balance.
7
6
1
2
3
7
6
1
2