Axis AD Series - 14.19 Density determination (hYdro); 14.19.1 Solids density determination

USER MANUAL 39
___________________________________________________________________________________________________________________
14.19 Density determination (hYdro)
The description below describes density determination using HYDRO kit. In case
below-balance weighing, operation sequence does not change.
14.19.1 Solids density determination
This function calculates material
density basing on its weight in air
and in water using the formula
below:
where, m
1
– weigh in air
m
2
– weight in water

L
- density of liquid
If distilled water is used, enter its
exact temperature (accurate to
0,5°C) – the balance will calculate
its density automatically.
To enter the value use the following
keys:
- digit increase,
- decimal point,
T - next digit,
MENU - end.
When using liquid other than
distilled water, choose OTHER
(instead of H2O) option and enter
its density according to its
temperature.
Phase I: measurement in air.
Phase II: measurement in liquid.
To print measurement result and
begin next measurement press
key.
L
mm
m
 *
21
1


0.000g
SOLId
H2O
t C
LOAD_H
LOAD_L
10.000g
9.000g
18
hYdro
hyd on
-
-
MENU
MENU
T
T
T
T
T