Axis AD Series - 14.19.3 Leaving the Function

42 USER MANUAL
__________________________________________________________________________________________________________________
To print a density determination report after all necessary measurements, connect
a printer to the balance and press key. A sample for liquid density
determination is shown below:
Date: ...
Time ...
MEASUREMENT NO.
= ...
WEIGHT in air
= ... g
WEIGHT in a liquid
= ... g
LIQUID DENSITY
PLUNGER VOLUME
= ... g/cm
3
= ... g/cm
3
14.19.3 Leaving the function
To stop using the function, follow
operation sequence as shown on the
picture.
In other case the balance begins
next density measurement.
LOAD_H
- -
0.000g
0.000g
6.6635
-
-
MENU