Axis AD Series - 14.12 Function for maximum value indication (UP)

USER MANUAL 29
___________________________________________________________________________________________________________________
14.12 Function for maximum value indication (UP)
This function allows holding on display maximum value shown by the scale in a
while
Before measurement the scale
should be tared.
After using MENU key, choosing
UP function , and then UP_on, the
highest mass result will be hold on
display.
Pressing  T  key will cause
result zeroing.
ATTENTION:
Autozeroing function and the
stabilisation indicator are
deactivated when UP function is
running. Weighing result is
continuously averaged from 5
measurements.
0.00 g
UP
UP oFF
UP on
0.00g
9.90g
9.90g
MENU
T
T
MAX
MAX
MAX