Axis AD Series User Manual

USER MANUAL 33
___________________________________________________________________________________________________________________
14.16 Average calculation function (AVErAGE)
The function allows for calculating average value of performed measurement
series. During series of measurements successive results are registered
automatically when scale indication is stabilised.
Press MENU key and select AUErAG
pressing  T  key.
The following will be shown
successively on display:
- AUE oFF – leaving function,
- AUE on – measurement with average
calculation.
- out
Select AUE on using  T  key. It will
allow weighing with simultaneous
storing results into summing register
for average calculation.
Measurement registration is
performed automatically in the
moment when scale indication
becomes stable. Short time displaying
of „ - - ” denotes that load can be
taken off and new one can be put on.
Results above scale Min are only
registered. Number of measurements
is limited to 9999.
In order to read average value key
should be used.
- first pressing causes displaying
number of measurements (n).
- second pressing causes displaying
average value (=).
- third pressing allows continuing
average calculation.
If a printer is connected to scale the
following report will be printed :
In order to finish calculation press MENU key, and then select AUErAGE i AUE
oFF.
Date: ... Time. ...
MEASUREMENS No = ...
AVERAGE VALUE = ...
0.00 g
0.00 g
AUErAGE
AUE on
1.00 g
2.00 g
2
1.50 g
_
_
0.00 g
0.00 g
0.00 g
MENU
T
T
n

Axis AD Series Specifications

General

Brand	Axis
Model	AD Series
Category	Scales
Language	English