46 USER MANUAL ME-01
Inscribing data to base
Prod and USEr options enables adding and deleting
product and user data.
For products database available options are:
- Prod Id – searching for product in database by
inscribing (or scanning) id number or barcode,
- ProdCLr (shows up if product was selected earlier) –
turns off actual product selection,
- EdIt – product edition from database,
- Add – add product to database,
- dEL OnE – deleting single element from database,
- dEL ALL – deleting all elements from database,
- dAtAb – changing working mode with database (default
mode Stb):
Stb – searching products in database and working
with products outside the base; if product is found
then Found communicate appears and all product
data is recalled; if there is no product in database
then no communicate appears, the scale stores
id/barcode number temporarily in memory and
enables to send it to the port (to printer/computer)
together with actual weighing result.
LIMIt – searching through products from database;
if product is found then Found communicate
appears and all product data is recalled; if there is
no product in database then not Found
communicate appears.
- Prn_P – sending all products database to port.
To inscribe data use EdIt option and keys:
0 - increasing digit,
T - next dixit,
MENU – end of inscribing.
Barcode reader (connected to RS232C interface) can
also be used to inscribe data and this way it is faster
and more effective.
Each database product has following data:
- M Id – memory cel number in products database,
- Prod Id – product identification number,
- Prod bA – product barcode,
- Prod nA – product name (inscribed from PC or barcode
reader),
- APW – product unitary weight (optional),
- PtArE – product package weight (optional),
- thr LO – lower threshold (MIN value),
- thr HI – upper threshold (MAX value).
Saving inscribed product data is done by using SAVE option.
To Next Page
Loading...
Need help?
General
