USER MANUAL ME-01 47
Users database is edited by similar function named USEr and consists of several options:
- USEr Id – user identification number,
- USErCLr (shows up if user was selected earlier) – turns off actual user selection,
- USEr nA – user name (inscribed from PC or scanner),
- Prn_U – sending users database to port.
Saving data is also done by SAVE option.
Recalling from database
The fastest way to recall product from database is
to readout his barcode number (Prod bA) by using
barcode reader (option). It can be done in any
moment.
After readout of proper barcode scale indicates one
of communicates:
- SCAn – barcode from outside the base accepted
(Std mode),
- not Found – barcode from outside the base not
accepted and no product is selected (LIMIt mode),
- Found – product barcode found in database and
data recalled.
Attention: If the scale doesn’t indicate any
communicate, check barcode reader connections,
port configuration and transmission protocol
(SErIAL function).
Other fast way is to press and hold MENU key
(about 3s). Prod Id communicate will appear.
Relase the key and inscribe identification number. If
the number is already saved in base Found
communicate appears and all the product data is
recalled.
To edit data choose EdIt option and use following
keys:
0 - increasing digit,
T - next dixit,
MENU – end of inscribing.
Product recalling is also possible by using Prod and
Prod Id options (previous site).
If You hold MENU key for a longer time (about 6s)
ProdCLr communicate will appear and actual
product selection will be turned off.
To Next Page
Loading...
Need help?
General
