Azbil C15 User Manual

5-14
Chapter 5. SETTINGS BEFORE STARTING OPERATION
Operation type Set
value of
operation
type
Direct action
z
shows that the ON/OFF is changed at this value.
 shows that the ON/OFF is changed at a point
that "1U" is added to this value.
Reverse action
z
shows that the ON/OFF is changed at this value.
 shows that the ON/OFF is changed at a point
that "1U" is added to this value.
Deviation low limit
(Final SP reference)
8
SP + Main setting
PV
SP + Main setting
PV
ONHYS
ON
HYS
Same as the direct action of the deviation low limit.
(The difference is that the SP ramp does not
use the current SP, but it uses the final SP.)
Same as the direct action of the deviation low limit.
(The difference is that the SP ramp does not
use the current SP, but it uses the final SP.)
Deviation high/
low limit
(Final SP reference)
9
Main setting
Sub-setting
PV
SP
ON
HYS
ONHYS
ONHYS
HYS
Main setting
Sub-setting
PV
SP
Same as the direct action of the deviation
high/low limit.
(The difference is that the SP ramp does not
use the current SP, but it uses the final SP.)
Same as the reverse action of the deviation
high/low limit.
(The difference is that the SP ramp does not
use the current SP, but it uses the final SP.)
SP high limit 10
ONHYS
ON
HYS
Main setting
Main setting
SP
SP
SP low limit 11
Main setting
SP
Main setting
SP
ONHYS
ON
HYS
SP high/low limit 12
Main setting Sub-setting Main setting Sub-setting
SP
SP
ON
HYS
ONHYS
ONHYS
HYS
MV high limit 13
ONHYS
ON
HYS
Main setting
Main setting
MV
MV
MV low limit 14
Main setting
MV
Main setting
MV
ONHYS
ON
HYS
MV high/low limit 15
Main setting
Sub-setting
MV
ON
HYS
ONHYS
ONHYS
HYS
Main setting
Sub-setting
MV
Heater 1 burnout/
Over-current
*
16
Main setting
Sub-setting
CT1 at output ON. CT1 at output ON.
ON
HYS
ONHYS
ONHYS
HYS
Main setting Sub-setting
OFF before measuring the CT1 current value OFF before measuring the CT1 current value

Azbil C15 Specifications

General

Brand	Azbil
Model	C15
Category	Controller
Language	English