Azeron CYBORG - 5.4. RESTRICTOR RING

Page | 30
| Manual
If you are using software version 1.5 and up, then you don’t need to follow these
instructions.
The restrictor ring will fit on the shortest thumbstick cap!
5.4. RESTRICTOR RING
In case you wish to use the included restrictor ring, then please follow
this video guide or these steps below:
1. Make sure the restrictor ring is removed from the keypad.
2. Calibrate the thumbstick in the Azeron software (how to)
3. Remove the thumbstick cap
4. Put on the restrictor ring, make sure the concave part is on the
thumbstick side.
5. Put back on the thumbstick cap
6. In the Azeron software go in the thumbstick settings: