ADSL2+ Ethernet USB Combo Router – Easy Start
NOTE: This is important especially if you have more than one Local Area
Connection icons displayed at the Network and Dial-up Connections /
Network Connections window. Ensure that you have selected the correct
one.)
1. Select Internet Protocol (TCP/IP) and click Properties. See Fig 1-16.
Figure 1-16 : Local Area Connection properties
Page 18 of 42
2. Select the option Obtain an IP address automatically and click OK. See Fig 1-17.
Figure 1-17 : TCP/IP Properties
3. Click OK again to close.
4. Ensure that your ADSL Router is powered ON.
5. Restart your system.
6. Proceed to
Chapter 5.
To Next Page
Loading...
Need help?
General
