ADSL2+ Ethernet USB Combo Router – Easy Start
Chapter 4 – Installing Your USB Driver (For Ethernet
USB Combo Router Only)
Setup utility will install the USB driver automatically. If it fails to install, follow the steps below
for USB installation. Proceed with this section ONLY if your computer/notebook is connected to
the USB Port of your ADSL Router. The following screen shots illustrated serve only as
examples. For any dissimilarity, please follow closely the instructions prompted on your
Computer/Notebook.
For Windows® 98 Second Edition users, you may be prompted for your Windows CD-ROM.
Have it ready by your side.
4.1 For Windows
®
98 Second Edition
Proceed with the steps below:
1. Power ON your computer to start the Windows Operating System.
2. Insert the Installation CD into your CD-ROM Drive.
3. At the prompt click Next. See Fig 1-18.
Figure 1-18 : Add New Hardware Wizard Prompt
4. Select Search for the best driver for your device (Recommended) option and click
Next. See Fig 1-19.
Figure 1-19 : Driver Search
Page 19 of 42
To Next Page
Loading...
Need help?
General
