1.8 Quickstart 31
During an explicit firmware update, the firmware file from inside the driver will be downloaded onto the device. In
order to become active the device must be power-cycled:
Firmware file will be downloaded during an firmware update...
When then re-attaching the device to the host system, the new firmware version will become active:
... after power-cycling the device it will be active
• The current firmware version of the device can be obtained either by using one of the applications which
are part of the SDK such as mvDeviceConfigure (p. 68) or by reading the value of the property Device/←-
FirmwareVersion or Info/FirmwareVersion using the API
• The current FPGA file version used by the device can be obtained by reading the value of the property
Info/Camera/SensorFPGAVersion
Using wxPropView the same information is available as indicated by the following figure:
MATRIX VISION GmbH
To Next Page
Loading...
