64
Exposure
time
10 us - 0.46 s 100 us - 10 s 10 us - 1 s 10 us - 1 s 10 us - 1 s 10 us - 10 s
ADC resolu-
tion
10 bit (10 / 8
bit transmis-
sion)
10 bit (10 / 8
bit transmis-
sion)
10 bit (10 / 8
bit transmis-
sion)
10 bit (10 / 8
bit transmis-
sion)
10 bit (10 / 8
bit transmis-
sion)
10 bit (10 / 8
bit transmis-
sion)
SNR 42 dB 40 dB 40 dB < 43 dB 37.4 dB
DR (nor-
mal / HDR
(p. 138))
55 dB / >
110 dB
61 dB / - > 61 dB / > 61 dB / > 61 dB / >
110 dB (with
gray scale
version)
65 dB /
Progressive
scan sen-
sor (no
interlaced
problems!)
X X X X X X
Rolling shut-
ter
- X - - X X
Global shut-
ter
X - X X - X
Trigger
(Hardware /
Software)
X / X X / - X / - X / - X / - X / X
Pipelined in
continuous
/ triggered
mode
X / - X / - X / - X / - X / - X / - (reset
only)
High color
reproductiv-
ity (for color
version)
X no no no no no
Programmable
readout tim-
ing with free
capture win-
dows and
partial scan
X X X X X X
Flash control
output, syn-
chronous to
exposure pe-
riod
X no no no no no
More specific
data
mv←-
BlueFOX-
[Model]200w
(0.4 Mpix
[752 x 480])
(p. 198)
mv←-
BlueFOX-
[Model]202a
(1.3 Mpix
[1280 x
1024])
(p. 201)
mv←-
BlueFOX-
[Model]202v
(1.2 Mpix
[1280
x 960])
(p. 204)
mv←-
BlueFOX-
[Model]202b
(1.2 Mpix
[1280
x 960])
(p. 208)
mv←-
BlueFOX-
[Model]202d
(1.2 Mpix
[1280
x 960])
(p. 211)
mv←-
BlueFOX-
[Model]205
(5.0 Mpix
[2592 x
1944])
(p. 215)
1
The operation in device specific AEC/AGC mode is limited in (non continuous) triggered modes. AEC/AGC only
works while trigger signal is active. When the trigger signal is removed AEC/AGC stops and gain and exposure will
be set to a static value. This is due to a limitation of the sensor chip.
2
Frame rate increase with reduced AOI width, but only when width >= 560 pixels, below frame rate remains
unchanged.
MATRIX VISION GmbH
To Next Page
Loading...
Need help?
General
