Connection panel 11
Connection panel
USB (RS232)
The USB sockets (two pieces) are for RS232 and RS485 connections to Home
Automation systems. A USB to RS232 (D-SUB 9) cable is needed; e.g. Bang & Olufsen
Part No. 6100051. For RS485 connections an RS232 to RS485 converter must be
added to the above mentioned cable.
When more than two system using RS232 protocol are connected a USB hub is
needed.
NETWORK LINK
The NETWORK LINK socket is for RJ45 connectors to connect the BeoLink Gateway
to the Network Link switch or B&O Recommended Router. The BeoLink Gateway will
either receive an IP address via DHCP or have a static IP address; see page 19.
IP-based Home Automation systems are connect to the Network Link in the same way.
Network Link Product Cable and Network Link Installation Cable, Cat 7 quality, are
recommended to avoid non-desired noise and interference.
~
The mains socket is for the connection to the mains.
MASTER LINK
The MASTER LINK sockets (RJ45 and ML) are used to connect products connected in a Master Link system. This makes it possible to control a
compatible audio and video system throughout the entire setup. The connections in the RJ45 socket are also found in the ML socket; see
page 58.
The RJ45 socket is used if the Master Link cable is equipped with an RJ45 plug.
The ML socket is used if the Master Link cable is equipped with a Master Link plug.
SETUP BUTTON
The SETUP BUTTON can be used during normal operation by pressing and holding the button; see page 12.
LED
The LED indicator gives feedback about the status of the system and about functions chosen with the SETUP BUTTON; see page 12.
LED SETUP BUTTON
NETWORK LINK
MASTER LINK
RJ45
ML
5V=
USB (RS232)
0.5A
5V
0.5A
USB (RS232)
NETWORK LINK
To Next Page
Loading...