Set up BeoLink Gateway - Setup - Integration Protocol - over RS232 25
Integration Protocol - over RS232
The Integration Protocol - Over RS232 (lower part of the page). The USB to RS232 converter cable, also used for connecting to the Bang & Olufsen
ServiceTool, can be used to connect each system using the RS232 protocol.
A bit rate must be selected.
Select between the following bit rates: 9600 bps, 19200 bps, 38400 bps, 57600 bps, and 115200 bps.
The RS232 connection does not require authentication.
To Next Page
Loading...