Set up BeoLink Gateway - Setup - Network 22
Setup
- In the Menu line click the tab Setup to go to Setup page that provides settings in three areas: Network settings, Date & Time and Integration
Protocol.
Network
In Network the BeoLink Gateway is set up to the
network it is connected to.
Hostname
The Hostname is the name of the BeoLink Gateway
as it is found in the LAN.
Note: The Hostname must always be a single word,
consisting of a combination of: capital letters, small
letters and digits.
DHCP
Per factory default DHCP is enabled, marked as
.
The default setting can be disabled by removing the
check mark
in the check box next to DHCP
enabled.
It is recommended to reserve an IP-address in the
router or use a static IP-address if DHCP is disabled.
Address
If the DHCP is disabled in the router, the IP-address must be entered manually in the Address eld. Default IP-address is 192.168.1.10.
Mask
Settings must be according to the same settings in the router for the Network Link. Typical value: 255.255.255.0.
DNS Server
Settings must be according to the same settings in the router for the Network Link. Example: 192.168.1.1 or an external server IP address.
Gateway
Settings must be according to the same settings in the router for the Network Link. Example: 192.168.1.1.
Apply
The above settings must be applied by pressing the
button.
To Next Page
Loading...