Bang & Olufsen BeoLink 1703 - Zone Setup; Resources for Area;Zone

Set up BeoLink Gateway - Interfaces - Zone setup 47
Zone setup
In this section of the Interfaces
page, for each zone it is possible
to reorder, rename, and hide/
show the resources as they will
be shown in the user interfaces.
Resources for area/zone
- (Reorder): For the resource
to be moved in the list, place the
cursor over the button, then
click and hold the left-mouse
button and then drag the
resource until the line-marking is
where the resource should be
paced in order and let go the
mouse button.
- Name: Possibility to rename the
resource
- Type: The type of the resource is
stated.
- Hidden:
√
= Hidden and = Shown in user interface.
- Options / Hints: For macros and buttons that are visible on the user interfaces the following options are available:
- Conrm: When a checkmark is set in the checkbox and when a button pressed or a macro is triggered the action needs conrmation on a
hand held device, e.g. pressing a
Yes
button to avoid unintended activation before the desired function is executed. This could be when an
action should not take place unintended, e.g. activating ‘Vacation mode’.
- Compact: When enabled a the button in the user interface will be shown in a half-width button. I.e. there is room for two buttons per line.
- On camera view: With ‘On camera’ enabled the half-width button will be shown next to the IP camera images in that zone on the user
interface.