Bang & Olufsen BeoLink 1703 - LED Indications; Functions - by Setup Button

LED indications 12
LED indications
The LED in the lover edge of the connection panel gives feedback about the system status of the BeoLink Gateway.
Green Red Description
Solid - Normal operation
Flashing quickly Flashing quickly Critical error
- Solid H8/FEP/FPGA update
Flashing slowly - Software update/System boot
- Flashing slowly Master Link synchronization
Functions - by Setup button
The Setup button placed next to the LED provides a number of functions as
described in the following.
- Press and hold the Setup button and the system will cycle through the functions. The LED indicates the function number by ashing red a number
of times: function no 1 = one ash, function no 2 = two ashes, etc.
- Count the number of red ashes while holding the Setup button, and when the desired number is reached let go the button.
- The LED indicator starts to ash red.
- To conrm the function execution the setup button should be pressed again within 3 seconds.
No. Function Description
1 System event Executing macros with EVENT
2 Reset password to default ‘Password’ to factory default
3 Fixed IP-address Enables the default static IP-address (192.168.1.10)
4 Factory default Erases conguration and settings
5 - -
6 Dynamic IP-address Enable DHCP (dynamic IP-address)