Set up BeoLink Gateway - Project 21
Set up the BeoLink Gateway
After login to the BeoLink Gateway, the menu bar is presented and the Project menu is opened per default.
In the following the menus in the menu bar (see below) and their submenus will be presented, describing the functions provided.
Project
The Project page (see illustration to the right) is used to
state information regarding the project that the
BeoLink Gateway is part of.
The information entered are useful in any later service
situation.
Note: Only the Display name is visible in the user
interfaces except the Webpanel (access directly on the
BeoLink Gateway).
- Project name i.e. a distinguishing name for the project/
setup; any name, number etc.
- Display name: i.e. a name of the BeoLink Gateway that will be shown in all interfaces: BeoLink App, WEB panel etc. Examples of display name are:
the family name or the name/number of the house.
- Installer name: i.e. name or initials of the installer in case of returning a question/comment to this.
- Installer contact: i.e. phone number, and company name, technician name, installer name re. the installer who made the installation and
programming of the BeoLink Gateway Setup.
To Next Page
Loading...